3DWash cleaning powder for Polymaker PolyDissolve™ S2

3DWASH has been specifically optimized for the removal of alkali-soluble support material in technical cleaning systems.

During development, a strong emphasis was placed on occupational safety.
This was achieved through a special chemical composition that allows optimal results at low pH values:
No heavy personal protective equipment is required when handling the cleaning agent, and the disposal of the used solution only requires dilution with water to meet globally recognized disposal standards*.

The following factors influence the effectiveness and time for the removal of support material:

• Motion/Circulation (varies depending on tank type and manufacturer)
• Temperature
• Part geometry and amount of support material
• pH value
• Chemical composition of the solvent

Results vary based on the above factors. Below are recommended guidelines for the use of 3DWASH.

Suitable Support Materials

3DWASH is suitable for all common support materials such as S2 by Polymaker, Stratasys SR-30, SR-35, etc., Arburg armat21.

Note

3DWASH is not suitable for HIPS or water-soluble support materials (PVA, BVOH, etc.) and cannot be used with support materials from other printing processes such as SLA or Polyjet technology!

Cleaning Temperatures

Water temperatures between 75 °C and 85 °C are most effective for dissolving support materials.
Dissolving at temperatures below 65 °C is nearly ineffective as the chemical process does not work at lower temperatures!